Bus Adapters (available from ). QLogic SANSurfer Management Suite CDROM (available from. the WWN Emulex LightPulse FC BIOS Utility, KAa: LPeM6: Bus#: Guide 2-Gbps Fibre Channel Host Bus Adapters FC A.1 Page i. document Troubleshooting Guide 2Gbps Fibre Channel Host Bus Adapters, available from.
|Published (Last):||25 October 2007|
|PDF File Size:||15.18 Mb|
|ePub File Size:||13.35 Mb|
|Price:||Free* [*Free Regsitration Required]|
The information in this guide is subject to change without notice. Configuration Maximums VMware vsphere 4. These device drivers are designed. No part of this manual may be reproduced or transmitted More information.
Use the value of “” if the actual result is higher. Use the default values for any parameters that are not listed in the following table. Exinda ExOS Version 6.
Record the value of [PWWN]. This guide provides procedures for installing the kit components. Fujitsu is committed to bringing you the best computing experience with your new system.
Check the values for each parameter in the port configuration screen. Customer Bulletin Product Model Name: The Drobo family of iscsi storage arrays allows organizations to effectively leverage the capabilities of a VMware infrastructure, including vmotion, Storage vmotion, Distributed Resource Scheduling DRS.
Compare with the parameter values in the following tables, and correct the current value if necessary. If the parameter is not shown, add the necessary information. The setup method described here uses QConvergeConsole, however, tools such as Fast! Chapter 1 Overview This chapter explains an overview. When you reset the password. Contents Introduction 1 Different ways to backup the system disk 2 Before More information.
Preface This manual briefly explains the operations More information. We cannot be held liable for any problems arising from. The following shows an example of this. For the installation method, installable positions or positions of the PCI bus slotsactivation of the installed slot, and notes regarding the Fibre Channel card, refer to the manual provided with the Fibre Channel card or the user guide of the server.
The following shows an example of this. Set the driver parameters using the following procedure: Hopkinton, MA www.
The workflow is shown below. UTIL Options] menu appears. Refer to “Appendix D: UTIL can also be used for the setup.
Record the IP address of the server. Fabric Point to Point” Configuring Ports and Port Channels This chapter includes the following sections: For more information about how to check the physical address, refer to the HBA manual.
The limits presented fc0506702 the. Software and Hardware Requirements Do not modify any parameters other than those described here.
To avoid this, it is recommended that a fixed Target ID be allocated to each device and automatic Target ID allocation be fx0056702. Refer to the following table and set the parameters.
FC-AL” For switch connections: The physical address and WWN of a Fibre Channel card are required information in the following cases: